Eaton easyE4 series Manual page 347

Description
I1 Input value that is to be put onto the NET.
Assigning operands
You can assign the following operands to the function block inputs that are numeric
inputs.
Operands
Constant, timer constant
MD, MW, MB - Markers
NB, NW, ND - NET markers
nNB, nND, nND- NET markers
NET stations n
IA - Analog input
QA - Analog output
QV - QV - Numeric output of a FB
You can assign the following operands to the function block inputs that are bit inputs:
Operands
Constant 0, constant 1
M – Markers
RN - Input bit via NET
SN - Output bit via NET (send)
N - Net marker bit
nN - NET marker bit NET station n
ID: Diagnostic alarm
LE - Output backlight
P buttons
I - Bit input
Q - Bit output
Q - Bit output of a FB
Function block outputs
Description
(Bit)
Q1 1: if the status of the trigger coil
PT..T_ is also 1.
AC 1: As soon as a transmit job is activ-
ated, or as soon as one is aborted
with an error message at output E1.
E1 Error - NET transmission error
1: If the value could not be sent and
easyE4 11/18 MN050009 EN www.eaton.com
6.1 Manufacturer function blocks
Note
Integer value
range:
-2,147,483,648
to
+2,147,483,647
Value inputs
x
x
x
x
x
x
x
Bit inputs
x
x
x
x
x
x
x
x
x
x
x
x
Note
This bit output is used for check-
ing whether the required value
was transferred to the NET.
6. Function blocks
343