Eaton easyE4 series Manual page 96

4. Operation
4.2 Operating modes of the easyE4
92
The main menu on the display is used to switch between operating modes, i.e., from
RUN to STOP and vice versa,→ Section "STOP RUN operating mode menu", page 95
If a program has not been stored on the easyE4, it will not be
possible to switch to RUN mode.
It will not be possible to do configuration work either.
In order to configure it, the program must be stopped.
STOP ✓ RUN
Operating mode changes may be protected with a password.
Ongoing operation
Table 5: Main menu
STOP RUN ✓
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM
easyE4 11/18 MN050009 EN www.eaton.com
To work on the easyE4
Table 6: Main menu
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM