Eaton easyE4 series Manual page 349

Write data to NET after each ...
<n> cycle
Parameter display
+ Call enabled
Simulation not possible
Other
Retention
The function block does not recognize retentive data.
See also
→ Section "GT - Get values from NET", page 339
→ Section "PT - Put values to NET", page 342
→ Section "Setting up a NET", page 537
easyE4 11/18 MN050009 EN www.eaton.com
6.1 Manufacturer function blocks
Description
at function block input T_ will be
required.
Can only be selected if No edge
evaluation of T bit input is enabled.
Function block parameters and con-
stants can be edited on the device.
6. Function blocks
Note
345