Configuring The Memory Card And Device Id - Eaton easyE4 series Manual

Hide thumbs Also See for easyE4 series:

Table of Contents

7.15 Configuring the memory card and device ID

Only possible with easySoft 7.

Select the device you want from the catalog in the Project view

Click on the System settings tab.

Go to the Memory card / device ID section and look for the Card start checkbox, the

Allow overwriting via card checkbox, and the numeric input field.

To turn on, enable the checkbox by clicking on it.

To turn off, disable the checkbox by clicking on it.

Card start, the device will access the memory card when it is switched on.

Allow overwriting via card, it will be possible for the

program that is found on the memory card to overwrite the program stored on the

You can enter a six-digit number as a Program/device ID into the input field.

This ID ensures that a program will be overwritten on the

easyE4 device only if the IDs match.

Table of Contents