Uv Light; Pointy, Sharp Objects And Corrosive Liquids; Installation Cut-Out; Mechanical Forces On The Ethernet Port - Eaton easyE4 series Manual

1. easyE4 control relays description
1.10 Safety regulations
34
exposed to environmental fluctuations, let the panel settle into the exist-
ing ambient temperature before switching it on.
CAUTION

UV LIGHT

Plastics will become brittle when exposed to UV light. This artificial
aging will reduce the easyE4 unit's lifespan. Protect the device from dir-
ect sunlight and other sources of UV radiation.
CAUTION

POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS

When cleaning the device:
Do not use any pointy or sharp objects (e.g., knives).
l
Do not use aggressive or abrasive cleaning products or solvents.
l
Make sure that no liquids get into the device (short-circuit hazard) and
that the device is not damaged in any way.
CAUTION

INSTALLATION CUT-OUT

The mounting cutout must be located in a position that will not defeat the
purpose of stabilizing webs or other reinforcing elements in the control
panel. If necessary, reinforcing elements must be installed/added.
WARNING
The device should only be run with safety extra-low voltage (functional
extra-low voltage with protective separation).
The power transformer must conform to the relevant standards.
CAUTION

MECHANICAL FORCES ON THE ETHERNET PORT

Communications may be affected, and the connection's mechanical
components may be damaged, if the Ethernet interface is subjected to
strong vibrations or the RJ45 plug-in connection is subjected to pulling.
Protect the RJ45 plug-in connection from strong vibrations.
l
Protect the RJ45 plug-in connection from tensile forces at the
l
socket.
easyE4 11/18 MN050009 EN www.eaton.com