Plausibility Check - Eaton easyE4 series Manual

6. Function blocks
6.3 UF - User function block

6.3.7.1 Plausibility check

448
A dialog box will appear and ask if you want to edit the user function block's name, ver-
sion, password, and/or comment before exporting it.
Yes— Yes: The "Edit user function block settings" dialog box will appear. Please note that if a password was
previously set for the user function block, you will need to enter it first. If you do not enter the pass-
word, a prompt will appear asking whether you still want to export the user function block.
No: No: The "Select user function block folder" dialog box will appear. You can then select the folder where
you want the user function block's uf7 file to be saved.
If the selected folder contains any items (files, folders, archives) with the exact same
name as the user function block being exported, you will not be able to notice this in
the "Select user function block folder" dialog box. Accordingly, make sure to first
check whether the selected folder is suitable for saving the file.
Clicking on the "Select Folder" button may result in any of the following scenarios if
there is a problem:
In the five cases below, you will be able to select a different folder:
1. The selected drive is not ready or is write-protected
2. The selected drive does not have enough free memory
3. The selected folder cannot be accessed
4. The selected folder is write-protected
5. The selected folder already contains a folder named UserFB_V1_01.uf7
In the first three cases, you will be asked whether you want to overwrite the file or
select a different folder.
1. The selected folder already contains an archive named UserFB_V1_01.uf7
2. The selected folder already contains a user function block named UserFB_V1_
01.uf7
3. The selected folder contains a write-protected user function block named
UserFB_V1_01.uf7.
If the aforementioned checks are all completed successfully, the user function block
will be saved and the user interface will be refreshed in the Programming view and in
the list of operands and function blocks if applicable.
When exporting a user function block, a user function block check that determines
whether the user function block can be executed in the easyE4 device's current state
will be triggered. This is especially necessary for user function blocks programmed
using ST, as entering impermissible operands is possible in these cases.
The export function will generate a uf7 file only if the user function block is executable.
In this case, the file will contain not only the actual user function block, but also all
required management data.
This check can be run at any time on user function blocks that are in use or that are not
in use in the project. The sole exception consists of password-protected user function
blocks in use.
easyE4 11/18 MN050009 EN www.eaton.com