Control Relays Mounting; Mounting Easye4 Control Relays - Eaton easyE4 series Manual

Hide thumbs Also See for easyE4 series:
Table of Contents

Advertisement

2.3 Mounting

2.3.1 Mounting easyE4 control relays

NOTICE
Arrange for a professional technician to mount the device.
CAUTION
INSTALLATION CUT-OUT
The mounting cutout must be located in a position that will not defeat the
purpose of stabilizing webs or other reinforcing elements in the control
panel. If necessary, reinforcing elements must be installed/added.
Check to make sure that the installation clearances are being observed
→ Section " Installation position", page 38
Make sure that the mounting cutout has the right size.
Mounting EASY-E4-...
Mounting on ICE/EN 60715 mounting rail OR
With screws and ZB4-101-GF1 mounting feet.
Install a easyE4 control relays in an enclosure, switch cabinet or distribution board so
that the power supply and terminal connections cannot be touched accidentally during
operation.
The easyE4 control relays can be mounted either vertically or horizontally.
For ease of wiring, leave a clearance of at least 3 cm between the device terminals and
the wall or adjacent devices.
easyE4 11/18 MN050009 EN www.eaton.com
2. Installation
2.3 Mounting
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents