Figure 65: Removing The Dust Plug From An Sfp+ Port - Allied Telesis x530 Series Installation Manual

Caution
Transceivers can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
devices.  E92
The illustrations in the procedure show a transceiver being installed in port
25 of a 28-port switch. The procedure is the same for all SFP and SFP+
ports.
To install transceivers, perform the following procedure:
1. If the transceiver port has a dust plug, remove it. Refer to Figure 65.
Figure 65. Removing the Dust Plug from an SFP+ Port
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. If you are installing the transceiver in a top port, position the
transceiver with the Allied Telesis label facing up. If you are installing
the transceiver in a bottom port, position the transceiver with the label
facing down.
4. Slide the transceiver into the port until it clicks into place, as shown in
Figure 66 on page 178.
x530 Series Installation Guide for Virtual Chassis Stacking
177