Parameter Window - Status Messages - ABB i-bus KNX FCA/S 1.1M Product Manual

ABB i-bus KNX
3.2.6.1 Parameter window
- Status messages
© 2010 ABB STOTZ-KONTAKT GmbH
Commissioning
In this parameter window, the Status messages are defined.
Enable communication object
"Status byte mode" 1 byte
Options: no
yes
yes: The communication object Status byte mode is enabled.
From this status byte the states HEATING, COOLING, automatic, forced
operation and the four limitations are indicated directly via a 1 bit coding.
For further information see:
With the option yes two further parameters appear:
Send object value
Options: no, update only
after a change
after request
after a change or request
no, update only: The status is updated but not sent.
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a
request.
Status byte, Forced operation, page 157
58