ABB i-bus KNX
4.2
System configuration with
a Fan Coil Actuator
© 2010 ABB STOTZ-KONTAKT GmbH
Planning and application
In this function the Fan Coil Actuator is used for control of the heating and
cooling valve as well as for switching the fan outputs. Temperature detection
is undertaken by a thermostat.
Even the offset of the set point value as well as changeover of the operating
modes is implemented by the thermostat. The sensors can be connected
directly to the Fan Coil Actuator in order to consider the monitoring of the
condensed water and the window contact.
In order to correctly implement this function, the thermostat must send the
actual temperature as well as the corresponding operating mode to the
Fan Coil Actuator via the bus.
131