Parameter Window - Status Messages (Multi-Level) - ABB i-bus KNX FCL/S 1.6.1.1 Product Manual

®
ABB i-bus KNX
Start-up
3.2.2.1.1

Parameter window - Status messages (Multi-level)

This is the parameter window where status messages are defined.
This parameter window is always visible for output A. For outputs C, D and E it is visible if the Outputs C,
D, E parameter in
Enable communication objects
"Status Fan speed x" 1 bit
Options:
The setting of a fan speed is displayed via these communication objects. You can parameterize whether or
not the status of a current or required fan speed is displayed.

Yes: Three 1 bit communication objects, Status speed x (x = 1...3) are enabled. The following parame-
ters appear:
Parameter window Enable outputs A...F
No
Yes
Meaning
Options: Current fan speed
Required fan speed
This parameter defines which status – Current fan speed or Required fan speed – is displayed.
on p.20 is set to Enable as fans.
FCL/S x.6.1.1 | 2CDC508116D0203 25