Table of Contents
Advertisement
ABB i-bus KNX
© 2010 ABB STOTZ-KONTAKT GmbH
Device technology
Supplied state
The device is supplied with the physical address 15.15.255.
The application program is pre-installed. It is therefore only necessary to
load group addresses and parameters during commissioning.
However, the complete application program can be reloaded if required.
A longer downtime may result if the application program is changed or after
a discharge.
Download behaviour
Depending on the PC which is used, the progress bar for the download may
take up to one and a half minutes before it appears due to the complexity of
the device.
Assignment of the physical address
The assignment and programming of the physical address is carried out
in the ETS.
Cleaning
If devices become dirty, they can be cleaned using a dry cloth. Should a dry
cloth not remove the dirt, the device can be cleaned using a slightly damp
cloth and soap solution. Corrosive agents or solutions should never be used.
Maintenance
The device is maintenance-free. No repairs should be carried out by
unauthorised personnel if damage occurs, e.g. during transport and/or
storage. The warranty expires if the device is opened.
Foil keypad
The manual control keys may not be operated with pointed or sharp-edged
objects, e.g. screwdrivers or pens.
This may damage the keypad.
16
Advertisement
Table of Contents
