Table of Contents
Advertisement
ABB i-bus KNX
3.3.2
Manual operation
© 2010 ABB STOTZ-KONTAKT GmbH
Commissioning
No.
Function
2
Enable/block manual
operation
The Manual operation of the Fan Coil Actuator is enabled or blocked via this communication
object.
Note
If this communication object is assigned to a group address,
the manual operation is blocked after each download, bus
reset or bus voltage recovery. If the communication object is
not assigned, manual operation is enabled.
If the value 0 is in this communication object, then the Fan Coil Actuator is switched over to
Manual operation using the (
During this setting the states of the inputs and outputs are transferred to the input terminals.
If the value 1 is in this communication object, then the Fan Coil Actuator is switched over to
bus operation.
Telegram value:
0 = enable
1 = block
3
LED ON/OFF
Using this communication object the LED ON/OFF is controlled on the foil keypad.
Telegram value:
0 = LED OFF
1 = LED ON
4
Button ON/OFF
Only by pressing the button will a telegram with the object value be sent.
Telegram value:
0 = button OFF
1 = button ON
5
Status manual Operation
On this communication object the Fan Coil Actuator sends the information regarding whether
it is in Manual operation or Operation via KNX.
The status is sent after a change.
Telegram value:
0 = operation via EIB/KNX"
1 = manual operation
Object name
Manual operation
) button on the device
button
button
Manual operation
Manual operation
Manual operation
Data type
Flags
EIS 1, 1 bit
C, W
DPT 1.003
EIS 1, 1 bit
C, W
DPT 1.001
EIS 1, 1 bit
C, R, T
DPT 1.001
EIS 1, 1 bit
C, R, T
DPT 1.003
95
Advertisement
Table of Contents
