ABB i-bus KNX FCA/S 1.1M Product Manual page 26

ABB i-bus KNX
© 2010 ABB STOTZ-KONTAKT GmbH
Commissioning
Functions of the keys:
Note
The respective LED indicates the current input states. The foil keypad can
be operated when manual operation has been activated.
If group addresses have been assigned, telegrams will be sent on the bus!
Any signal changes from the installed system will not be considered.
On switchover to the operating state KNX operation, the respective LEDs
again indicate their current input states.
The communication objects are updated and telegrams are sent.
ON/OFF
Options: Indication "Status automatic"
LED/button with objects
Note
The button has no further functions with both options.
Indication "Status automatic": The LED indicates the current operating
state of the Fan Coil Actuator:
LED on = fan automatic activated
LED off = fan automatic not activated
LED/button with objects: The communication objects LED ON/OFF
(No.: 3) and Button ON/OFF (No.: 2) appear.
With these communication objects it is possible to freely select the
function.
Speed
Options: enabled
disabled
With this parameter the button can also be enabled or disabled.
Enabled: The button is enabled.
Disabled: The button is disabled.
Note
By pressing the Speed button
switched through. This is according to the following sequence:
0 => 1 => 2 => 3 => 0 => 1 => 2 => 3 =>...
The speeds are indicated in the sequence:
Fan speed 1 with LED ,
Fan speed 2 with LED ,
Fan speed 3 with LED .
If none of the speed LEDs are on the fan is off.
the individual fan speeds can be
24