ABB i-bus KNX FCA/S 1.1M Product Manual page 66

ABB i-bus KNX
© 2010 ABB STOTZ-KONTAKT GmbH
Commissioning
The highest priority is assigned to limitation 1, e.g. frost/heat protection;
the lowest priority is assigned to limitation 4, e.g. standby operation.
Fan speed with limitation 1
Fan speed with limitation 3
Options: inactive
unchanged
OFF
ON
With this parameter you set which fan speed is set with active limitation,
or which speed is not exceeded or undershot.
Fan speed with limitation 2
Fan speed with limitation 4
Options: inactive
unchanged
OFF
ON
With this parameter you set which fan speed is set with active limitation,
or which speed is not exceeded or undershot.
64