Allen-Bradley LOGIX 5000 Reference Manual page 174

Chapter 1 Process Control Instructions
174
AtuneCV2Changed BOOL
AtuneCV3Changed BOOL
AtuneCV1Timeout BOOL
AtuneCV2Timeout BOOL
AtuneCV3Timeout BOOL
AtuneCV1PVNotSettled BOOL
AtuneCV2PVNotSettled BOOL
AtuneCV3PVNotSettled BOOL
Status1 DINT
Status2 DINT
Status3CV1 DINT
Status3CV2 DINT
Rockwell Automation Publication 1756-RM006K-EN-P - November 2018
CV2Oper is changed when in
Operation control or CV2Prog is
changed when in Program control or
CV2 becomes high/low or ROC
limited during CV2 Autotuning.
When True, CV2 Autotuning is
aborted.
CV3Oper is changed when in
Operation control or CV3Prog is
changed when in Program control or
CV3 becomes high/low or ROC
limited during CV3 Autotuning.
When True, CV3 Autotuning is
aborted.
Elapsed time is greater then
AtuneTimeLimit since step test is
started. When True, CV1 Autotuning
is aborted.
Elapsed time is greater then
AtuneTimeLimit since step test is
started. When True, CV2 Autotuning
is aborted.
Elapsed time is greater then
AtuneTimeLimit since step test is
started. When True, CV3 Autotuning
is aborted.
The PV is changed too much to
Autotune for CV1. When True, CV1
Autotuning is aborted. Wait until PV
is more stable before autotuning
CV1.
The PV is changed too much to
Autotune for CV2. When True, CV2
Autotuning is aborted. Wait until PV
is more stable before autotuning
CV2.
The PV is changed too much to
Autotune for CV3. When True, CV3
Autotuning is aborted. Wait until PV
is more stable before autotuning
CV3.
Bit mapped status of the function
block.
Additional bit mapped status for the
function block.
Additional bit mapped CV1 status for
the function block. A value of 0
indicates that no faults have
occurred.
Additional bit mapped CV2 status for
the function block. A value of 0
indicates that no faults have
occurred.