Figure 22: Attaching The Handles To The At-Rkmt-J14 Brackets; Figure 23: Attaching The At-Rkmt-J14 Brackets To The Switch - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 4: Installing the Switch on a Table or in an Equipment Rack
62
Figure 22. Attaching the Handles to the AT-RKMT-J14 Brackets
2. Place the switch on a level, secure surface.
3. Attach the two brackets to the sides of the switch in the selected
position, using the eight M4x6mm screws included with the unit. The
illustration in Figure 23 shows the installation of the brackets such that
the front panel of the switch is even with the front of the equipment
rack.
Figure 23. Attaching the AT-RKMT-J14 Brackets to the Switch