Figure 25: Attaching The Handles To The At-Rkmt-J14 Brackets; Figure 26: Attaching The At-Rkmt-J14 Brackets To The Switch - Allied Telesis x550 Series Installation Manual

Chapter 3: Installing the Switch on a Table or in an Equipment Rack
66
Figure 25. Attaching the Handles to the AT-RKMT-J14 Brackets
2. Place the switch on a level, secure surface.
3. Attach the two brackets to the sides of the switch in the selected
position, using the eight M4x6mm screws included with the unit. (Refer
to Figure 23 on page 64 and Figure 24 on page 65.) The illustration in
Figure 26 shows the installation of the brackets such that the front
panel of the switch is even with the front of the equipment rack.
Figure 26. Attaching the AT-RKMT-J14 Brackets to the Switch