Table of Contents
Advertisement
Low Limit Flow Alarm
Example:
1)
Place RATE knob to the lowest application rate, typically this will be
RATE 1.
2)
Enter a SELF TEST speed.
3)
Observe the volume/minute ("FLAn").
4)
Enter a lower SELF TEST speed.
5)
Repeat steps 3 & 4 until the lowest acceptable spray pattern is reached.
6)
Record minimum volume/minute when the spray pattern is acceptable.
this value for the minimum flow ("LLAn").
Tier Enable
Example:
Main spray bar capacity
Tier 2 capacity
Tier 3 capacity
Total System capacity
Set Tier 2 Enable at 15 (gal/min)[lit/min](main spray bar)Set Tier 3 Enable
at 45 (gal/min)[lit/min](main spray bar + tier 2)Percentage tier disable
default is 10%. In this case, tier 2 would be enabled at 15.0 (gal/min)[lit/
min] and disabled at 13.5 (gal/min)[lit/min].
45.0 (gal/min) [lit/min] and disabled at 40.5 (gal/min) [lit/min].
10. AREA/HOUR
Displays number of lane miles being covered per hour.
then the area per hour value will also be zero.
11. BLAST BUTTON
1)
Depressing the BLAST button will cause the system to go to the programmed Blast
Rate.
The system will remain at the Blast Rate for as long as the button is
depressed plus the programmed Blast Time after the button is released.
BLAST button is used with zero speed the Console will assume a speed of 5 MPH
[7 Km/hr].
2)
To display the number of times the BLAST feature was used, depress and hold
for 5 seconds until right DATA display flashes.
enter a "0".
12. CONTROL VALVE DELAY
Depress
( X 0 0 0 ), is the Control Valve delay digit.
set a delay between the time the MASTER is turned on and when the Console begins
to control the application rate.
respectively.
-
-
-
-
until the right DATA display flashes.
A value of 0 means no delay.
15 (gal/min) [lit/min]
30 (gal/min) [lit/min]
60 (gal/min) [lit/min]
105 (gal/min) [lit/min]
Tier 3 would be enabled at
This feature allows the user to
A value of 1-9 means a delay of 1-9 seconds
18
If lane width is zero
If the
To zero this total,
The first digit,
Enter
Advertisement
Table of Contents
