Switching From Liquid Application To Spinner Spreader Configuration - Terragator Only; Install The Accuboom Node - Raven AccuBoom Installation Manual

11. Connect the appropriate jumper cable to the AccuBoom harness. Refer to the following table to choose the
jumper cable.
TABLE 1.
Application
RoGator Liquid
RoGator AirMax 180
TerraGator Liquid
TerraGator AirMax/AirSpread
TerraGator Spinner Spreader
SWITCHING FROM LIQUID APPLICATION TO SPINNER SPREADER CONFIGURATION -
TERRAGATOR ONLY
When switching from a liquid application to a spinner spreader application on a TerraGator, AccuBoom must be
removed from the system before the machine will operate correctly. Complete the steps in this section to convert
the TerraGator system from a liquid to a spinner spreader application.
1. Disconnect the AccuBoom harness cable from the TerraGator Section T connection in the access panel and
reconnect the Section T together.
2. Disconnect the AccuBoom Logic Power connector from the TerraGator Aux Pwr connector in the access panel.
3. In the Viper Pro Miscellaneous Settings screen, change the AccuBoom node from Combo to AccuBoom Only.
NOTE: Repeat the steps above in reverse order to convert the system from a spinner spreader application to
a liquid application.

INSTALL THE ACCUBOOM NODE

NOTE: The AccuBoom node (P/N 063-0172-714) is sold separately. Contact your local Raven dealer for
ordering information.
Manual No. 016-1001-063 Rev. E
Jumper
Liquid Jumper
AirMax 180 Jumper
Liquid Jumper
Dry Jumper
Remove AccuBoom and refer
to the next section
ACCUBOOM INSTALLATION
11