Overview Of Site Planning Steps; Chapter 2 Power And Cooling - Cisco CRS-1 Site Planning Manual

Chapter 1 Cisco CRS Carrier Routing System

Overview of Site Planning Steps

Table 1-1
the table as a checklist for all aspects of the installation. For information about a particular task, see the
appropriate section of this site planning guide. After completing the checklist, you should consult your
Cisco installation coordinator for a site-readiness inspection
Table 1-1 Site Planning Checklist
Site Planning Steps
1. Determine where to install the routing system
and make sure that you have the appropriate
installation and configuration tools.
2. Consider equipment arrival, storage, and
transport to the installation site.
3. Make sure that the equipment rack meets the
installation requirements.
Consider the space where the routing system
4.
will be installed.
Plan for power (fixed or modular
5.
configuration power, AC or DC).
Consider cooling and airflow requirements.
6.
7. Consider cable management.
Consider Cisco installation services.
8.
OL-5802-09
lists the sequence of tasks to perform as you plan the installation of the routing system. Use
See
"Basic Site and Installation Planning" section on page 4-1
"Tools Required for Installation" section on page 4-2
"Basic Site and Installation Planning" section on page 4-1
"Equipment Rack Specifications" section on page 3-4
"Equipment Rack Considerations" section on page 4-3
"Aisle Spacing and Maintenance Access Floor Plan" section on
page 4-4
Chapter 2, "Power and Cooling"
"Line Card Chassis Specifications" section on page 3-1
"Chassis Airflow" section on page 2-19
"Facility Cooling Requirements" section on page 2-20
"Environmental Specifications" section on page 3-7
"Cable Management" section on page 4-6
"Cisco Installation Services" section on page 4-8
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Site Planning Guide
Overview of Site Planning Steps
Check
1-11