Cpx-Fec; Configuration; B.1 Cpx-Fec - Festo CPX-CMIX-M1-1 Manual

B. Configuration with CPX node
B.1

CPX-FEC

B.1.1 Configuration
Festo P.BE-CPX-CMIX-EN en 1208a
General information on configuration using the FST is
provided in the CPX-FEC manual (type P.BE-CPX-FEC-...).
Detailed information on operating the FST can be found in the
FST manual (type P.BE-FST-...).
Use Festo Software Tools (FST 4.1 or higher) with the
Hardware Configurator in order to configure your CPX
terminal with CPX-FEC.
To configure the CMIX, this must be in the catalogue of the
CPX configurator (CPX terminal / Technology module /
CPX-CMIX...). You may require an FST software update for this
(CPX configuration update):
www.festo.com
Software, Drivers and firmware
Caution
If you have connected a CPX terminal to your PC for
configuration: Test projects and programs at first without
active actuators or without compressed air.
You will then avoid damage in the test phase.
I/O configuration / CPX configuration
You can create the configuration in the following ways:
– Nominal/actual comparison in the editor mode
– Change to the online mode
– Manual configuration with the Hardware Configurator
The first two methods require the CPX terminal to be
connected and ready for operation. The hardware
configuration with the CMIX is automatically recognised.
Downloads Download Area:
Enter search term: CMIX
B-3