Resetting To Status As At Delivery - Festo CPX-CMIX-M1-1 Manual

3. Commissioning
3.5

Resetting to status as at delivery

3-18
This is how to reset the CMIX to the condition at delivery:
1. Switch off power supply of the CPX terminal.
2. Remove cable to the measuring system or sensor
interface.
3. Switch on power supply of the CPX terminal.
4. Set the bit LOAD_P in the control byte CCON
(0 -> 1, positive edge).
5. Switch off power supply of the CPX terminal.
6. Plug cable back in to the measuring system or
sensor interface.
7. Switch on power supply of the CPX terminal.
The CMIX is back in the delivery condition.
Festo P.BE-CPX-CMIX-EN en 1208a