Parameterising The Cmix; Save Actual Configuration As The Nominal Configuration - Festo CPX-CMIX-M1-1 Manual

B. Configuration with CPX node
Module
CPX-CMIX sensor
Interface
Tab. B/1: CMIX technology module
B.1.2 Parameterising the CMIX
B.1.3 Save actual configuration as the nominal configuration
Festo P.BE-CPX-CMIX-EN en 1208a
Input word / Output word addresses
Set the start address of the input words and output words of
the CMIX.
Module Allocated address
identifiers space
T23 CMIX 3 Input words (6 bytes)
3 Output words (6 bytes)
The CMIX does not have any module parameters.
In order to save the changes permanently, after the changes:
– the actual configuration must be saved as the nominal
configuration,
– or the project must be loaded into the CPX-FEC
(a program must exist for this).
Note
Make sure that you have supplied taught parameters, or
parameters edited via the keyboard or the CPX-MMI, to the
CPX configurator.
Remarks
For assignment of the
addresses, see section B.1.4.
B-5