2. Fitting and installation
2.2
Fitting and removing the CMIX
Removal
1
CMIX
2
Interlocking block
3
Contact rails
4
TORX T10 screws
Fig. 2/1: Removal/fitting of the CMIX
2-4
The CMIX is mounted in an interlinking block (see also
section 2.6) of the CPX terminal, see Fig. 2/1.
Note
Always switch off the power supply before fitting or
•
removing CPX modules.
Note
The CMIX contains electrostatically sensitive components.
Therefore, do not touch any components.
•
Observe the handling specifications for electrostatically
•
sensitive components.
Remove the CMIX as follows:
1. Loosen the four screws of the CMIX with a T10 TORX
screwdriver.
2. Pull the CMIX carefully and without tilting away from the
power rails of the interlinking block.
4
3
Festo P.BE-CPX-CMIX-EN en 1208a
1
2