Set Ipv4 Dns; Set Ipv4 Dhcp - Network Critical SmartNA-X User Manual

Syntax
set ipv4 gateway ipv4-address
Parameters
ipv4-address Specify the IPv4 address of the gateway, in dotted-decimal format (a.b.c.d).
Example
Define IPv4 gateway 192.168.0.1, and then exit the CLI to implement:
CONTROLLER>set ipv4 gateway 192.168.0.1
Network settings will take effect when you exit CLI.
exit to enable new network settings
CONTROLLER>exit
Exiting CLI
exit to enable new network settings
Applying new IPv4 network settings
Addressing Mode : static
Address: 192.168.0.122
Netmask: 255.255.255.0
Gateway: 192.168.0.254
Connection to 192.168.0.122 closed.
admin@example.com:~$

set ipv4 dns

Use the set ipv4 dns command to define an IPv4 address for an IP Domain Name System (DNS) server. Adding a DNS
server allows the use of server names at the command line. Changes to network interface settings are implemented after
exiting the CLI, or immediately if connecting over IPv6 or via the Console port.
Syntax
set ipv4 dns ipv4-address
Parameters
ipv4-address Specify the IPv4 address of the DNS server, in dotted-decimal format (a.b.c.d).
Example
Define DNS server 192.168.100.1, and then exit the CLI to implement:
CONTROLLER>set ipv4 dns 192.168.100.1
CONTROLLER>exit
Exiting CLI
Connection to 192.168.0.122 closed.
admin@example.com:~$

set ipv4 dhcp

Use the set ipv4 dhcp command to acquire an IP address for the Ethernet interface from the Dynamic Host Configuration
Protocol (DHCP) server. DHCP client configuration implicitly removes the static IP address configuration on the
interface. Changes to network interface settings are implemented after exiting the CLI, or immediately if connecting over
IPv6 or via the Console port.
Syntax
set ipv4 dhcp
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 99