Set Port Name - Network Critical SmartNA-X User Manual

• MDI-X Set MDI-X (crossover) mode.
Example
Set port 3A MDI to MDI-X:
CONTROLLER>select slot 3
SLOT3>set port A mdi mdi-x
SLOT3>show port A
speed : set auto actual 1G
duplex : set auto actual full
: set mdi-x actual mdi-x
mdi
mastering : set preferslave actual master
autoneg : auto
tap : off
autolock : off
lock : off
description: Web router downstream port
usage : network
port type : Registered Jack 45 (RJ45)
PORT UP
traffic threshold low : 0
traffic threshold high: 100
SLOT3>commit
Committing maps and vline
SLOT3>

set port name

Use the set port name command to enter a name/description for the port.
Syntax
set port port-id name description
Parameters
• port-id Specify the port letter to set or show. A–D for front ports; 0 or 1 for rear ports.
• description Enter a name or suitable description for the port. Surrounding quotes are not required.
Example
Set port 3A name/description to Web router downstream port:
CONTROLLER>select slot 3
SLOT3>set port A name Web router downstream port
SLOT3>show port A
speed : set auto
duplex : set auto
mdi : set auto
mastering : set preferslave
autoneg : auto
tap : off
autolock : off
lock : off
description: Web router downstream port
usage : undefined
port type : Registered Jack 45 (RJ45)
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100
SLOT3>commit
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 119