Delete Radius Accserver; Show Tacacs; Create Tacacs Authserver - Network Critical SmartNA-X User Manual

Parameters
ipv4 Specify the IPv4 address of the RADIUS Accounting server to add.
•
• port Specify the RADIUS Accounting server port number (usually 1813).
• shared-secret Specify the server-client shared secret (if set).
Example
Add the following RADIUS accounting server; show all RADIUS servers:
• Address: 192.168.10.24
• Port: 1813
• Shared secret: mySecret
CONTROLLER>create radius accserver 192.168.10.24 1813 mySecret
CONTROLLER>show radius
No authentication servers
Accounting Server 192.168.10.24 port 1813

delete radius accserver

Use the delete radius accserver command to remove a RADIUS accounting server. If no other accounting servers are
configured then transaction logging will be disabled, since local accounting is not supported.
Syntax
delete radius accserver server-addr
Parameters
ipv4 Specify the IPv4 address of the RADIUS Accounting server to delete.
Example
Delete RADIUS accounting server 192.168.10.25:
CONTROLLER>delete radius accserver 192.168.10.25

show tacacs

Use the show tacacs command to show a list of all configured TACACS+ servers.
Syntax
show tacacs
Parameters
This command has no arguments or keywords.
Example
List TACACS+ servers:
CONTROLLER>show tacacs
Authentication server 192.168.10.24
Accounting Server 192.168.10.25

create tacacs authserver

Use the create tacacs authserver command to add TACACS+ Authentication servers (one server per command).
Login credentials are checked across all servers until a match is found. Make sure the authentication scheme (set
authentication) includes tacacs when authenticating by TACACS+ server.
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 107