Snmp Commands; Snmp Show Agent; Snmp Enable Agent; Snmp Disable Agent - Network Critical SmartNA-X User Manual

SNMP commands

This section provides information for SNMP commands:
Note: The apply command must be entered before configuration commands take effect

snmp show agent

Use the snmp show agent command to show the enabled/disabled status of the SNMP agent. By default the SNMP agent
is disabled and must be enabled with the snmp enable command in order to expose system management data to an SNMP
manager and for SNMP notifications (traps) to be sent.
Syntax
snmp show agent
Parameters
This command has no arguments or keywords.
Example
Show the enabled/disabled status of the SNMP agent:
CONTROLLER>snmp show agent
SNMP : Enabled

snmp enable agent

Use the snmp enable agent command to enable the SNMP agent. Enabling the agent allows SNMP managers to access
system management data and for SNMP notifications (traps) to be sent.
Syntax
snmp enable agent
Parameters
This command has no arguments or keywords.
Example
Enable the SNMP agent:
CONTROLLER>snmp enable agent
CONTROLLER>snmp show agent
SNMP : Enabled
CONTROLLER>apply

snmp disable agent

Use the snmp disable agent command to disable the SNMP agent. Disabling the agent prevents SNMP managers from
accessing system management data and prevents SNMP notifications (traps) from being sent.
Syntax
snmp disable agent
Parameters
This command has no arguments or keywords.
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 143