Appendix E: Supported Mibs - Network Critical SmartNA-X User Manual

198 | Supported MIBs | SmartNA-X 1G/10G Modular
Supported MIBs
List of MIBs supported by this device.
Please note that some MIBs are only partially supported. To request a copy of the MIB files used by Network Critical
devices, please contact support at the following address: support@networkcritical.com.
• NCPRODUCTIDS-MIB—Unique IDs for Network Critical products.
• NCSYSTEM-MIB—Information specific to TAPs and proprietary notifications (traps). The 64-bit packet in and out
counters (psHCInPackets and psHCOutPackets respectively) in NCTAP-MIB are accessible through SNMPv2 and v3
only. This is a limitation in the SNMPv1 standard.
• NCTAP-MIB—Information specific to TAPs and proprietary notifications (traps). The 64-bit packet in and out
counters (psHCInPackets and psHCOutPackets respectively) in NCTAP-MIB are accessible through SNMPv2 and v3
only. This is a limitation in the SNMPv1 standard.
• IANAifType-MIB—Interface types referenced in IF-MIB.
• IF-MIB—Partial read-only support of objects in this MIB. The following restrictions apply to objects within the
NlmLogVariableTable table:
• nlmLogVariableID (supported)
• nlmLogVariableValueType (supported)
• nlmLogVariableTimeTicksVal (supported for 1st entry only)
• nlmLogVariableInteger32Val (not supported)
• nlmLogVariableOctetStringVal (not supported)
• nlmLogVariableOidVal (not supported)
The following restrictions apply to objects within the NlmLogTable table:
• nlmLogTime TimeStamp (supported)
• nlmLogDateAndTime DateAndTime (supported)
• nlmLogEngineID SnmpEngineID (not supported)
• nlmLogEngineTAddress TAddress (not supported)
• nlmLogEngineTDomain TDomain (not supported)
• nlmLogContextEngineID SnmpEngineID (not supported)
• nlmLogContextName SnmpAdminString (not supported)
• nlmLogNotificationID (accessible by column only)
• SNMP-FRAMEWORK-MIB—Read-only support of objects in this MIB.
• SNMP-NOTIFICATION-MIB—Read-only support of objects in this MIB.
• SNMP-TARGET-MIB—Read-only support of objects in this MIB.
• SNMP-USER-BASED-SM-MIB—Read-only support of objects in this MIB.
• SNMP-VIEW-BASED-ACM-MIB—Read-only support of objects in this MIB.
• SNMPv2-CONF-MIB—Conformance definitions referenced in SNMPv2-MIB.
• SNMPv2-MIB—System info and SNMP notifications (coldStart, warmStart and authenticationFailure)
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
Appendix
E