set port duplex
(Copper ports only) Use the set port duplex command to specify a duplex setting for a port, either half-duplex, full-
duplex, or auto-duplex (default). If using fixed duplex, ensure the link partner matches the same setting.
Syntax
set port port-id duplex { Auto | Half | Full }
Parameters
•
port-id Specify the port letter to set or show. A–D for front ports; 0 or 1 for rear ports.
•
Auto Set duplex auto-negotiation. For this setting to be effective, the overall port negotiation must be set to auto-
negotiate, this can be done using the command set port autoneg auto.
•
Full Set full-duplex mode.
•
Half Set half-duplex mode.
Example
Set port 3A to full-duplex:
CONTROLLER>select slot 3
SLOT3>set port A duplex full
speed
: set auto actual 1G
duplex
: set full actual full
mdi
: set mdi-x actual mdi-x
mastering
: set preferslave actual master
autoneg
: auto
tap
: off
autolock
: on
lock
: off
description: Web router downstream port
usage
: network
port type
: Registered Jack 45 (RJ45)
PORT UP
traffic threshold low : 0
traffic threshold high: 100
set port lock
Use the set port lock command to lock/unlock the specified port. A port that is locked is unable to pass traffic, and
indicates a link-down status.
Syntax
set port port-id lock { On | Off }
Parameters
•
port-id Specify the port letter to set or show. A–D for front ports; 0 or 1 for rear ports.
•
On Lock the port and stop all traffic on that port.
•
Off Unlock the port and allow traffic to pass on that port.
Example
Lock port 3A:
CONTROLLER>select slot 3
SLOT3>set port A lock on
speed
: set auto actual 1G
duplex
: set auto actual full
mdi
: set mdi-x actual mdi-x
mastering
: set preferslave actual master
autoneg
: auto
tap
: off
™
©
SmartNA-X
1G/10G User Guide 1.4
2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 117
Need help?
Do you have a question about the SmartNA-X and is the answer not in the manual?