Delete Map - Network Critical SmartNA-X User Manual

My Filter
Destination Ports:
LB1
2.
Source Ports:
LB1
Destination Ports:
port 1C
port 1D
port 2C
port 2D
CONTROLLER>commit
Committing maps and vline

delete map

Use the delete map command to remove the specified map, as identified by its map number when you run the show maps
command. Maps are ordered sequentially and may change after deleting a map, therefore always use show maps before
deleting a map to determine the correct map number. After deleting maps, enter a commit command to replace the live
settings on the device with your new configuration.
Syntax
delete map map-number
Parameters
map-number Specify the map number to delete. Map numbers are shown in the listing provided by show maps and
•
are updated each time a map is deleted.
Example
• Show maps, delete map 4, and commit changes to the system:
CONTROLLER>show maps
CONTROLLER>show maps
maps
1.
Source Ports:
1A
Destination Ports:
1B
1C
2.
Source Ports:
1B
Destination Ports:
1A
3.
Source Ports:
1B
Excluded Filters:
HTTP
Destination Ports:
3D
4.
Source Ports:
1B
Destination Ports:
3C
5.
Source Ports:
1B
Required Filters:
SMTP
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 125