Network Configuration Commands; Show Ntp; Create Ntp; Delete Ntp - Network Critical SmartNA-X User Manual

Network configuration commands

This section provides reference information for network configuration commands.

show ntp

Use the show ntp command to display the NTP time-server address.
Syntax
show ntp
Parameters
This command has no arguments or keywords.
Example
Display the NTP server address:
show ntp
CONTROLLER>
NTP server : 192.168.254.21

create ntp

Use the create ntp command add an NTP time-server. After adding an NTP server, the system will attempt to synchronize
the internal clock with the NTP server.
Syntax
create ntp address
Parameters
address Specify the IPv4 address of the NTP server.
Example
Specify an NTP server with address 192.168.0.10:
CONTROLLER>create ntp 192.168.0.10

delete ntp

Use the delete ntp command to delete NTP settings.
Syntax
delete ntp
Parameters
This command has no arguments or keywords.
Example
Delete NTP settings:
CONTROLLER>delete ntp
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 97