Set Port Packetprocessor Transform; Set Port Packetprocessor Clear Transform - Network Critical SmartNA-X User Manual

176 | Command Line Reference | SmartNA-X 1G/10G Modular
Examples
Show packet processor speed.
CONTROLLER>show packetprocessor speed
Configured as 4 x 1G

set port packetprocessor transform

Use the set port packetprocessor transform command to apply a Transform to a port.
Each port supports eight Transforms, numbered 1 to 8. The show port command can be used to view what transforms
have been applied to a port. If all the matches of a Transform match the packet contents, the actions associated with that
Transform will be taken. The lowest numbered Transform only will be actioned, and all higher numbered transforms will
be ignored (lowest numbered Transform takes priority).
To see a list of Transforms, use the show packetprocessor transforms command. The pre-configured Transforms are
listed in section
Syntax
set port port -id packetprocessor transform transform-number transform-name
Parameters
port-id
Port to set, either A, B, C or D.
transform-name
The name of the packet processor Transform to set.
transform-number
The Transform number, 1-8 to set. Lower numbers have higher priority.
Examples
Apply "remove v2 header" as Transform 7 to port 1A.
SLOT1>set port A packetprocessor transform 7 "remove v2 header"
SLOT1>commit
Committed packet processing

set port packetprocessor clear transform

Use the set port packetprocessor clear transform command to clear a port transform.
Syntax
set port port -id packetprocessor clear transform transform-number
Parameters
port-id
Port to set, either A, B, C or D.
transform-number
The Transform number, 1-8 to clear.
Packet Processor Preset Matches
™
SmartNA-X
section.
©
1G/10G User Guide 1.4 2015 Network Critical Solutions Limited