Snmp Show All - Network Critical SmartNA-X User Manual

144 | Command Line Reference | SmartNA-X 1G/10G Modular
Example
Disable the SNMP agent:
CONTROLLER>snmp disable agent
CONTROLLER>snmp show agent
SNMP : Disabled
CONTROLLER>apply

snmp show all

Use the snmp show all command to show all SNMP information, including agent status, enabled notifications,
communities, users, and other SNMP details.
Syntax
snmp show all
Parameters
This command has no arguments or keywords.
Example
Display all SNMP information:
CONTROLLER>snmp show all
SNMP : Enabled
SNMP notify : on
system notify : on
health notify : on
Community number 0
IP protocol version : ipv4
comString : public
Community Type : ro
oid :
source :
Engine ID : 0x80007b9d03001dff031009
User number 0
Engine : local
EngineId :
Name : u1
Auth type : md5
priv type : des
User number 1
Engine : local
EngineId :
Name : u2
Auth type : sha
priv type : aes
SectoGroup number 0
Security Model : usm
sec name : u1
group name : g1
SectoGroup number 1
Security Model : usm
sec name : u2
group name : g1
View number 0
view type : include
mibTree : .1
mask :
name : v1
Access number 0
group name : g1
Security Model : any
Security Level : priv
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited