Delete Radius Authserver; Create Radius Accserver - Network Critical SmartNA-X User Manual

106 | Command Line Reference | SmartNA-X 1G/10G Modular
user1 Cleartext-Password := "User1Password
Reply-Message = "audit"
user2 Cleartext-Password := "User2Password
Reply-Message = "user"
user3 Cleartext-Password := "User3Password
Reply-Message = "admin"
Syntax
create radius authserver ipv4 port-id shared-secret
Parameters
• ipv4 Specify the IPv4 address of the RADIUS Authentication server to add.
port Specify the RADIUS Authentication server port number (usually 1812).
•
shared-secret Server-client shared secret.
•
Example
Add the following RADIUS Authentication server; enable RADIUS and fallback to local authentication:
• Address: 192.168.10.22
• Port: 1812
• Shared-secret: radiusSecret
CONTROLLER>create radius authserver 192.168.10.22 1812 radiusSecret
CONTROLLER>set authentication radius local
Change accepted

delete radius authserver

Use the delete radius authserver command to remove a RADIUS Authentication server. Ensure your authentication
scheme (set authentication) includes local if no Authentication servers are configured, to prevent becoming locked out of
the system.
Syntax
delete radius authserver ipv4
Parameters
ipv4 Specify the RADIUS Authentication server address.
Example
Remove RADIUS authentication server 192.168.10.22:
CONTROLLER>delete radius authserver 192.168.10.22
removing RADIUS server

create radius accserver

Use the create radius accserver command to add RADIUS Accounting servers (one server per command). Adding
an accounting server implicitly enables transaction logging on the accounting server(s). Note that local logging is not
supported by the system.
Syntax
create radius accserver ipv4 port-id shared-secret
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited