Set Filter Ipv6 - Network Critical SmartNA-X User Manual

port
source : 80,8080,443
ipv4
source : 10.10.0.*
destination : 192.168.0.*
CONTROLLER>commit
Committing maps and vline
Committing filters
CONTROLLER>
Define a filter that matches IPv4 packets with an ICMP type field of 6, and a pre-defined custom field (called "CF-1")
value of 8. Review and commit to the system.
CONTROLLER>set filter "Example filter" ipv4 protocol icmpv4 icmp type 6 customfield "CF-1" 8
CONTROLLER>show filters
Use commit command to configure the switch with these.
filters
Example filter
packetType : ipv4
protocol : 1
icmpType : 6
customField
CF-1 : 8
CONTROLLER>commit
Committing maps and vline
Committing filters
CONTROLLER>

set filter ipv6

Use the set filter ipv6 command to create filters for packets that match packets of ether-type IPv6. The filter can be
further refined by specifying IPv6 layer 2, 3 and/or layer 4 headers, plus any user pre-defined custom fields within the
IPv6 scope.
Syntax
set filter filter-name IPv6 [ VLAN tag ] [ PCP level ] [ MAC src mac-id ] [ MAC dest mac-id ] [ MAC either mac-
id ] [ Address src ip ] [ Address dest ip ] [ Address either ip ] [ Protocol protocol-number or name ] [ DSCP class ] [
Customfield custom-field-name value ]
set filter filter-name IPv6 protocol TCP [ Port src port-number ] [ Port dest port-number ] [ Port either port-number
] [ cwr flag-value ] [ ece flag-value ] [ urg flag-value ] [ ack flag-value ] [ psh flag-value ] [ rst flag-value ] [ syn flag-
value ] [ fin flag-value ] { other filtering options }
set filter filter-name IPv6 protocol { UDP | TCP | TCP_UDP | SCTP } [ Port src port-number ] [ Port dest port-
number ] [ Port either port-number ] { other filtering options }
set filter filter-name IPv6 protocol ICMPV4 [ ICMP type type-value ] [ ICMP code code-value ] { other filtering
options }
Parameters
filter-name Specify a unique, case-sensitive, name for the filter. The name may contain spaces, but if it does it must be
contained in quotes "..." (the name cannot itself contain quotes).
VLAN tag Filter by Virtual LAN (VLAN) tag. Use one of the following formats to specify a single or multiple tags:
100 single tag
•
100–110 inclusive tag range
•
0/1 a value/mask tag pair (here all even tags)
•
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited
SmartNA-X 1G/10G Modular | Command Line Reference | 133