Snmp Create Host; Snmp Delete Host - Network Critical SmartNA-X User Manual

148 | Command Line Reference | SmartNA-X 1G/10G Modular
Version Set : v2c
sec name : public

snmp create host

Use the snmp create host command to configure recipients (hosts) for SNMP notifications.
If several notify directives are specified for the same host, multiple copies of each notification (in the appropriate formats)
are generated. There is a 30-second timeout for notifications. If the system is unable to reach a host during the timeout
period, it will retry up to three times in a five-minute period.
Syntax
snmp create host HOST { v1 | v2c | v3 } [ community ] [ Trap | Inform ] [ EngineID ]
Parameters
• HOST Specify the recipient hostname or IP address, and optionally define a transport specifier (UDP or UDP6) and a
port number. The expanded format for HOST is [transport-specifier:]transport-address, where:
transport-specifier is either udp: (default) or upd6:
•
• transport-address[:port], where transport-address is either a hostname or IP, and :port is an optional port id.
If no transport-specifier or port is given then UDP and port 162 are assumed.
• v1, v2c, v3 Select the SNMP version used by the host.
• community/user Specify the community string (SNMPv1/v2c) or user (SNMPv3).
Trap, Inform Choose a notification format, either Traps (unacknowledged notifications) or Informs (acknowledged
•
notifications). If using Informs, you must set the EngineID of the remote host.
• EngineID Specify the SNMP EngineID of the host. You must specify the remote host's EngineID if using Inform
notifications.
Examples
• Create an SNMPv3 host – assumes UDP, port 162, and Trap notifications:
CONTROLLER>snmp create host hostaddress v3 user
CONTROLLER>apply
• Create an SNMPv3 host for Inform notifications – assumes UDP and port 162:
CONTROLLER>snmp create host hostaddress v3 user remoteEngineID
CONTROLLER>apply
• Create an SNMPv2c host – assumes Trap notifications:
CONTROLLER>port v2c community
CONTROLLER>apply

snmp delete host

Use the snmp delete host command to delete recipients (hosts) for SNMP notifications.
Syntax
snmp delete host HOST { v1 | v2c | v3 } [ community ] [ Trap | Inform ] [ EngineID ]
Parameters
HOST Specify the recipient hostname or IP address, and optionally define a transport specifier (UDP or UDP6) and a
•
port number. The expanded format for HOST is [transport-specifier:]transport-address, where:
• transport-specifier is either udp: (default) or upd6:
transport-address[:port], where transport-address is either a hostname or IP, and :port is an optional port id.
•
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited