Exit - Network Critical SmartNA-X User Manual

92 | Command Line Reference | SmartNA-X 1G/10G Modular
Parameters
mins Specify a timeout, in minutes, for CLI sessions. Valid range 1–1440 (1 minute to 24 hours). Default value 15
minutes. Use 0 to disable session timeouts.
Example
Set the CLI session timeout to 30 minutes:
CONTROLLER>set timeout 30
CONTROLLER>show system
Device Name: Network Critical
Device Contact:
Device Location:
MAC address: 00:1d:ff:21:92:c5
IPv4 Addressing Mode : static
IPv4 Address: 192.168.0.123
IPv4 Netmask: 255.255.255.0
IPv4 Gateway: 192.168.0.3
IPv4 DNS Server: None configured
Stored IPv6 Global Address : ::
Stored IPv6 Prefix Length : 0
Stored IPV6 Gateway : ::
IPv6 Link Local Address : fe80::21d:ffff:fe21:92c5
Active IPv6 Global Address : ::
Active IPv6 Prefix Length : 0
Active IPv6 Gateway : ::
SNMP:
Chassis Type:
Power Supply 1:
Power Supply 2:
Time and Date:
System Timeout:

exit

Use the exit command to stop the current CLI session and return to the host operating system. Any pending changes will
be lost if they are not committed before exiting. Any updates made to the network interface settings will be implemented
upon exiting the CLI.
Syntax
exit
Parameters
This command has no arguments or keywords.
Example
CONTROLLER>exit
Exiting CLI
Connection to 192.168.0.122 closed.
admin@example.com:~#
on
1U
DOWN
UP
11:23:20 Fri 21 Mar 2014
30 minutes
™
SmartNA-X 1G/10G User Guide 1.4
©
2015 Network Critical Solutions Limited