Snmp Enable Notify; Snmp Disable Notify - Network Critical SmartNA-X User Manual

146 | Command Line Reference | SmartNA-X 1G/10G Modular
SNMP notify : on
system notify : on
health notify : off

snmp enable notify

Use the snmp enable notify command to turn on SNMP notifications.
An SNMP notification is a message sent from the device to the SNMP management station indicating that a certain event
has occurred, such as a link up/down (see the parameters list below for a list of triggering events for each notification
type). This device supports three notifications types: SNMP, system, and health. By default, all notifications are disabled
on the device. When a notification type is enabled, the system sends notifications of that type to all SNMP hosts. Note that
the snmp apply command is not required after use of the snmp enable notify command.
Syntax
snmp enable notify { SNMP | System | Health | All }
Parameters
SNMP Turn on SNMP notifications. Events which trigger an SNMP notification are (SNMP message name shown in
•
brackets):
• System cold boot (coldStart)
• System restarted (warmStart)
• SNMP authentication failure (authenticationFailure)
• System Turn on System notifications. Events which trigger a System notification are:
• Port link-up state (linkUp)
• Port link-down state (linkDown)
• Data rate above high threshold (nctapNotifyXSTrafficOver)
• Data rate below low threshold (nctapNotifyXSTrafficUnder
• Module inserted or removed (nctapNotifyCard)
• Failed login attempt (ncUnauthorisedAccess)
• Health Turn on Health notifications. Events which trigger a Health notification are:
• System temperature above threshold (nctapNotifySysTemperature)
• Module temperature above threshold (nctapNotifyTemperature)
• Power on/off (nctapNotifyPower)
• Fan on/off (nctapNotifyFan)
• All Turn on notifications for SNMP, System, and Health.
Example
Turn on Health notifications:
CONTROLLER>snmp enable notify health
CONTROLLER>snmp show notify
SNMP notify : off
system notify : off
health notify : on
CONTROLLER>apply

snmp disable notify

Use the snmp disable notify command to turn off SNMP notifications.
An SNMP notification is a message sent from the device to the SNMP management station indicating that a certain event
has occurred, such as a link up/down (see the parameters list below for a list of triggering events for each notification
™ ©
SmartNA-X 1G/10G User Guide 1.4 2015 Network Critical Solutions Limited