2.4
Application Settings
Set the supplementary cyclic settings, IP address, or other parameters for the Simple Motion module.
Item
Supplementary Cyclic
Settings
IP Address
Communication Mode
Parameter Name
Dynamic Routing
Event Reception from
Other Stations
Module Operation Mode
Interlink Transmission
Settings
Safety Communication
Setting
2 PARAMETER SETTINGS
74
2.4 Application Settings
Description
Set the link scan mode, station-based block data assurance, and I/O maintenance setting.
Set the IP address of the master station to communicate with Ethernet device over CC-
Link IE Field Network.
Set the communication mode of the own station.
Set a name for the module parameter if desired.
Select whether to enable the dynamic routing function.
Select whether to obtain the events occurring in the other stations.
Set the mode of the Simple Motion module.
Set link device ranges when cyclic data are transferred from a station in the own network
to a station in another network.
Set whether to use the safety communication function or not and set the safety
connections and transfer ranges of safety devices.
This item can be set only in a project of the Safety CPU.
Reference
Page 75 Supplementary Cyclic
Settings
Page 75 IP Address
Page 76 Communication Mode
Page 76 Parameter Name
Page 76 Dynamic Routing
Page 76 Event Reception from
Other Stations
Page 77 Module Operation Mode
Page 77 Interlink Transmission
Settings
Page 81 Safety Communication
Setting