Mitsubishi Electric RD77GF8 User Manual page 45

Rules for the IP address setting
IP addresses specified for the IP packet transfer function need to satisfy the following rules.
Device to be set
Ethernet device
Ethernet-equipped module connected
to the Ethernet device
Simple Motion module
Remote head module
Simple Motion module on the
communication path (not connected to
an Ethernet device)
*1 Set the Nos. according to the range applicable to the Ethernet device used. The range may not apply depending on the Ethernet device.
Check the specifications of the Ethernet device used.
Setting range of the IP address
First and second octets

*1
0.0 to 223.255
(Same Nos. for the request source
device, request destination device,
and modules between them)

Automatically set (Same value as the
master station)
0.0 to 223.255
IP address setting not required
Third octet
, , 
*1
1 to 239
(Same No. for the Ethernet device
and the Ethernet-equipped module)
, 
Automatically set (network No. of the
own station)
1 to 239
1.5 IP Packet Transfer Function
Fourth octet

*1
1 to 120

Automatically set (station No. of the
own station)
• 1 to 120
• 125 (125 is always set in the
master station.)
1 FUNCTIONS
1
43