Mitsubishi Electric RD77GF8 User Manual page 59

■Setting in the CPU module 1 and master station 1 (station No.0)
1.
Set the routing parameters to the CPU module 1 as follows.
Navigation window  "Parameter"  Target module  "CPU parameter"  "Routing Setting"
Because the network address is different from that of the request destination device, the Ethernet adapter module 2 (Ethernet
part) does not have a network No. Set the communication path to the network No.2.
2.
Set the IP address in the master station 1 (station No.0) as follows.
Navigation window  "Parameter"  "Module Information"  Target module  "Module Parameter (Network)" 
"Application Settings"  "IP Address"
3.
Write the set parameters to the CPU module 1. Then reset the CPU module 1 or power off and on the system.
■Setting in the CPU module 2, local station 1 (station No.2), and master station 2 (station No.0)
1.
Set the routing parameters to the CPU module 2 as follows.
Navigation window  "Parameter"  Target module  "CPU parameter"  "Routing Setting"
2.
Set the IP address in the master station 2 (station No.0) as follows.
Navigation window  "Parameter"  "Module Information"  Target module  "Module Parameter (Network)" 
"Application Settings"  "IP Address"
3.
The IP address setting is not required for the local station 1 (station No.2).
The network address set in the master station 1 (station No.0) is automatically assigned.
4.
Write the set parameters to the CPU module 2. Then reset the CPU module 2 or power off and on the system.
1 FUNCTIONS
1.5 IP Packet Transfer Function
1
57