■When the module that is not supported is connected
When the module that is not supported such as servo amplifier is connected, the status of the station is not displayed.
Cable Test
Cable test checks if the Ethernet cables are properly connected.
Only the Ethernet cable connected to the P2 of the target station is tested. For the whole network status, check the network
map or "Selected Station Communication Status Monitor" of the CC-Link IE Field Network diagnostics. (Page 105
Checking the Network Status)
■Procedure
4 TROUBLESHOOTING
116
4.3 Checking the Network Status
1.
Click the [Cable Test] button in the "CC-
Link IE Field Diagnostics" window.
"Cable Test" window is displayed.
2.
Enter a station No. and click the [Execute
Test] button to operate the test.
If an error occurs, take actions according to the
error message.