PrimeLab 1.0 MULTITEST User Manual page 345

PrimeLab Desktop Assistant
Menu: Parameter / Install new parameter on the device
By using the JENCOLOR sensor the PrimeLab device is able to test for all water
values whose colour development after addition of a reagent occurs in the visible
colour spectrum.
This also means that the list of water values that can be measured by PrimeLab will
continuously grow.
So that your PrimeLab is always up-to-date you can acquire codes to unlock further
parameters / measurement methods on your device.
!
Unlocking codes are not free of charge.
Please contact your specialist dealer
to acquire an unlocking code.
Click on the menu "Parameters".
Double click on the parameter group for which you want to activate a measurement
method.
The following symbols will be shown behind the measurement methods after double
clicking on the parameter group:
• green tick: This measurement method is activated and available
• construction sign: This measuring method is under development / not yet available
• shopping basket: This measurement method can be activated by a code
Click on the shopping basket.
In the following window enter the eight
character unlocking code acquired from
your dealer. Please mind upper and
lower case characters in the code!
Confirm your entry by clicking "Activate".
The measurement method activated by
the code is immediately available and
installed on PrimeLab.
PDA-31 PDA-31