PrimeLab 1.0 MULTITEST User Manual page 17

Menu: MEM (Memory)
Browse test results
Press button 3 in the start menu to access the MEMORY menu.
First you will see how many data sets are saved in memory. "Used:
3
28/100" signifies, for example, that 28 saved data sets are stored in a
maximum of 100 memory spaces available.
Scroll up and down the list using button 2 or 3 respectively until the entry
2
"Browse results" appears white on black".
3
Then press button 4.
4
Select the address data set to which you would like to have the saved test
2
results displayed.
3
Confirm your selection by pressing button 4.
4
Scroll up and down the list using button 2 or 3 respectively and select
2
either "View by test" (selection a) or "View all data" (selection b).
3
Confirm your selection by pressing button 4.
4
Selection a) You selected "View by test" to display a list sorted by
parameters. Scroll up or down the list using the buttons 2 or 3 respectively
2
3
until the required parameter list appears white on black.
Confirm the selected parameter group by pressing button 4 and then
select the test method with the buttons 2 and 3 for which you would like to
view the test results.
4
Confirm your selection by pressing button 4.
Now use the buttons 2 and 3 to scroll through the measurement results.
2
These will be displayed in chronological order. If you have defined ideal
3
ranges (Menu: Setup) the test results will display as "Low" / "OK" / "High".
Press button 4 to change from a unit for which the result has been
4
displayed (e.g. "mg/l CaCO " to "°dH"), as far as available, or you can
delete the result directly.
1
Press button 1 to return one step back or up in the menu.
MEM 1
3
MEM 1