PrimeLab 1.0 MULTITEST User Manual page 320

PrimeLab Desktop Assistant
Start Software & automatic synchronisation of test data
1) Make sure that your PrimeLab is switched on and the Bluetooth
module is activated. This is indicated by the symbol "BLUE" in white
on black in the top right-hand corner of your PrimeLab display. If this
is not the case, please follow the instructions on page "SET 1".
2) Click on the icon "PrimeLab" on your desktop or under START -> All
programs -> PrimeLab Desktop Assistant.
3) After a short while the window shown is
displayed to inform you on the loading progress
of the program. This can take some time because
the software will look for PrimeLab devices
connected to your PC via Bluetooth , which will
then be listed in the next selection window.
On the display of your PrimeLab the message
"Remote control" should be displayed.
4a) If the message "No PrimeLab found" is displayed
make sure that steps (1) and (2) can be
confirmed, i.e. that PrimeLab is switched on and
successfully connected to your PC. If the error
message is repeated although you are certain
that PrimeLab is switched on and connected to
your PC via Bluetooth right click (!) the
Bluetooth icon in the task bar or in Windows
system control panel, select "Show Bluetooth
network devices", click on in the PrimeLab
symbol shown in the next window and select
"Remove". Then reconnect to PrimeLab as
described on pages PDA-2 and PDA-3. Then
restart the software "PrimeLab Desktop
Assistant".
4b) Normally the software will start
with a selection window showing
all connected PrimeLab devices.
Select the device you want to
work with and click on "OK".
PDA-6
®
®
®
®
®
PrimeLab.exe
Continued...
PDA-6