PrimeLab 1.0 MULTITEST User Manual page 332

PrimeLab Desktop Assistant
Menu: Setup /
Enter water treatment products
for dosage recommendations
The "PrimeLab Desktop Assistant" can be used make a dosage recommendation on
the basis of the measurement results, so that the water on which the measurement
is based can be returned to your defined quality range using water treatment
products.
So that you can be as flexible as possible it is necessary that you not only define
the ideal ranges for each measurement method (e.g. pH value ideal range = 7.20 –
7.40) and store the amount of water for each account (e.g. 50 m³ pool), but that you
also save your individual water treatment products (e.g. pH Minus granulate),
because the dosage recommendations will and can only be calculated on the basis
of the information:
Click on the SETUP
menu and select the
first tab (Water
treatment products).
Select the water
parameter for which
you want to store
water treatment
products.
Now select if you
want to enter a
treatment product to
increase or decrease
the water value after
adding it.
Depending on the
selection either a green plus sign "+" or a red minus sign "-" is displayed in front of
your entry.
It is best to name your entry by using the actual name of the water treatment
product.
In the following step you determine whether it is a liquid, granular or tablet water
treatment product and the quantity (units determined by you, e.g. "ml", "g" or "pc.")
per litre ("/l") to change value by how much (also determined by you).
Refer to the details on the packaging or the instructions to your water treatment
product.
Repeat this for all water parameters for which you intend to provide dosage
recommendations. You can enter more than one water treatment product per water
parameter! The dosage recommendation will then consist of several suggestions.
Remove entries or change them by Select/Change and clicking on the respective
buttons.
PDA-18
Measurement value – ideal range –
water quantity (source) – water treatment product
PDA-18