Slave Mode; Switching Operation To Slave Mode - IDEC WB1F Series User Manual

1. Overview 2. Installation & wiring
3. 2

Slave mode

This operation mode is used during normal operation. Use the unit in this mode after installation.
Slave mode has the following functions.
Barcode reading ......................................................
z
Output data additional information ................
z
Output data editing ...............................................
z
Matching method ...................................................
z
Analysis .......................................................................
z
Command alias ........................................................
z
Communication command .................................
z
3. 2. 1

Switching operation to slave mode

There are two methods to switch to slave mode.
Use the methods according to the situation.
The indicator LEDs (red/orange/green) will turn off when switching to slave mode.
Method 1 Turn on the power to the unit. (Do not push the Operation button)
Turn on power supply
Method 2 Input the "switch to slave mode" control command.
Host device
Function
F P. 3-4
F P. 3-11
F P. 3-16
F P. 3-18
F P. 3-23
F P. 3-24
F P. 3-26
Control command
Switch to slave mode
4. Support tool
RS-232 Type
Indicator LED
(G)
(O)
(R)
O
Indicator LED
(G)
(O)
(R)
O
5. Appendix
Slave mode
USB Type
3-3