Cisco Catalyst 3560-X Command Reference Manual page 1090

debug pm
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-82
Downloaded from www.Manualslib.com
The undebug pm command is the same as the no debug pm command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02